Whilst there are forums to help with tech tips I thought I'd

just show mine in pictorial format to help those who have never

looked under the tank or thought a simple job to be a nightmare

It is hoped this will at least help

Air filter change

Very simple tools required

1/4 drive socket 8mm and 7mm sockets and a 6 inch extension

Allen key for seat removal 5mm (if memory serves)

(click on thumbnails to enlarge)

lift the corners of the seat towards the rear to reveal the allen head bolts

View under seat

Locate the tank stay left side of the frame

you will need to remove tail pod or seat to remove

if this item is missing/lost use a 12" socket extension as a prop

Using a socket 8mm undo 2 retaining bolts

and prop with tank stay

With 7mm socket undo the airbox bolts not forgetting the one right at the back

Ease out the top cover to reveal the filter

which can now be changed

(note do not worry if you find oil in the airbox this is quiet common

with this model)

*****************************************************

Evoluzione Complete Race Airbox Kit with Air Filter

This is a worth while mod

Increases air box volume by 30% by using the underside of your gas tank as the top of the air box.

  Proven performance gain of 3-4 hp

Very easy to install 5mm allen key is all that is required

Follow the above steps to the point of airbox cover removal

Remove air filter and place new rubber sealing ring, on top

for this place the aluminium ring inserting the allen head bolts through both the

aluminium ring and the rubber seal clamping securely in place

Add filter from kit and reassemble

*****************************************************

Power commander install

Locate the pc111 (power commander) on top of the ecu with Velcro

provided, attach earth wire to battery

Remove left frame cover this is to assist in threading the pc111

loom under the tank

from the pc111 there are two sub looms

one length is longer than the other, the longer one will

go to the right hand side of the bike

the other to the left (shorter one)

Right hand side, I fed my loom between the two cylinders, locate loom

block right hand side, its attached throttle bodies just below air box

this will move as it is on a bezel so don't fear you have broken it

it is retained by to small clips that require squeezing to release

once free plug in the sub loom from the pc111

Left side locate grey plug a little hidden behind a some t pieced tubes

again requires a squeeze action to remove, plug in the sub loom

There is one grey wire left to locate

to the rear on right-hand side is a black plug

again a squeeze to release type

Locate the CENTRE wire this will be brown with yellow trace

using the scotch block and the connection and make water tight

you can now either get your bike set up on a dyno

 or use one of the maps to suit your mods from the cd provided

Back